How to configure Multiple Risk Item types

From version 23.7.7 multiple Risk(row) Item types are supported.
Here is a short instruction on how to enable it:

Previously it was possible to have only one Work Item Type specified as a row Risk item, but now you can have a special column holding Risk item type, that you can select when creating a new Risk item.

1. Specify Risk Work Item Types:

In the "dataTypes" section of the Risksheet configuration put comma-separated IDs of Work Item types that will correspond to the Risk level.

...
"dataTypes": {
    "risk": {
      "type": "risk,issue"
    },
...

2. Create a specific column that shows Type:

When creating a new Risk item you would be able to specify from the dropdown menu what WI type should it be created;

...
{
      "headerGroup": "Potential Failure",
      "headerGroupCss": "headPotentialRisks",
      "headerCss": "headPotentialRisks",
      "header": "Item Type",
      "bindings": "type",
      "minWidth": 150,
      "id": "itemType",
      "level": 2
    },
...

Note! When the item is already created it is no longer possible to change its type.

Also, check our article on how to create multiple downstream item types: click here

In case of issues, please send a message to: [email protected]